26 27
LOCAL ALARM CONFIGURATION
Like Local Schedule Configuration, above, this Local Alarm Configuration allows you to
record events directly onto your computer regardless of what the settings are on the actual
DVR. However, this tab will cause the system to record only when motion is detected or when
video loss occurs.
STEP 1. Select a camera
STEP 2. Select the type of alarm - Motion Detection or Video loss. Both can be used, but
each will type is handled differently and so must be set individually.
STEP 3. Select what activity each type of alarm will trigger - Motion Detection can trigger
an audible alarm on the computer, a flashing notification on the E-Map (discussed later in
Section 4.4) and/or cause the camera - and other cameras to start recording. Video loss can
trigger an audio alarm and/or an E-map notification.
STEP 4. If you have selected Chanel Record as a triggered events, you will be given a list
of cameras that can be set to record when the camera you are configuring detects motion.
Check all those cameras you wish to record when triggered.
STEP 5. Once you have completed configuring a camera, you can copy the settings to other
cameras using the “Apply Settings to” drop-down and pressing Copy.
4.3 SERVER CONFIGURATION
Where the previous windows allowed you to create settings for the CMS system and the
computer it is operating on without changing the settings on the DVR, Server Configuration
lets you alter the settings on a selected DVR as you would from within the DVR itself.
When you first select Server
Configuration, you will be presented with
a message directing you to select a device
(DVR) from the list of systems on the left of
the Control Center.
Once you have selected a system, a menu
of available settings will be presented. This
is the same set of options available from
within the DVR’s menu and they can be
adjusted in the same manner as on the
DVR.
Please consult the manual that
accompanied your DVR . The manual
is also available at www.Q-See.com/
support.
Sensors
CMS can also monitor sensors connected to
the DVR and they can be set to trigger alarms
or cause cameras to record in the same way
cameras can trigger actions.
Sensors, however, do not appear on the
E-Map.
Clicking on the DVR itself in the list of
connected devices will produce a list of
available sensor ports. Clicking on the sensor
port will allow you to select which event(s)
will be triggered by that sensor. If there isn’t
a sensor actually connected to that port,
nothing will happen even though you can
configure an action.
(23 strony)
(36 strony)
(120 strony)
(54 strony)
(75 strony)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji